INTRODUCTION
Arduino
product family is a great learning platform for electronics, programming and
robotics. But most projects at some point require mobility. This Arduino motor
shield allows for motor control with Arduino right away. Stack up this shield
on your controller and drive 2 DC motors with higher power requirements.
Depending on the motor of choice, you can make it fast or handle a higher
payload. This Arduino Motor Shield (2A) uses L298P chip which allow to drive
two 7-12V DC motors with maximum 2A current. This arduino motor shield can be
directly mounted onto standard Arduino Uno and Arduino
Mega.
Speed
control is achieved through conventional PWM which can be obtained from
Arduino’s PWM output Pin 5 and 6. The enable/disable function of the motor
control is signaled by Arduino Digital Pin 4 and 7. The Motor shield can be
powered directly from Arduino or from external power source. It is strongly
encouraged to use external power supply to power the motor shield.
This
arduino motor shield is ideal for building Arduino robot or other Arduino motor
control projects.
There is another version of 2x2A motor shield (Twin) which uses different pins to avoid conflicting pin
allocation.
Compatibility
SPECIFICATION
·
Logic Control Voltage:5V (From Arduino)
·
Motor Driven Voltage:6.5~12v(VIN Power Supply),4.8~35V (External Power Source)
·
2 way motor drive
·
Logic supply current Iss:≤36mA
·
Motor Driven current Io:≤2A
·
Maximum power consumption:25W(T=75℃)
·
Up to 2A current each way
·
Pin 4,5,6,7 are used to drive two DC
motor
·
Support PWM speed control
·
Support PLL advance speed control
·
Size: 55x55mm (2.2x2.2 in)
DOCUMENTS
·
WIKI (Arduino Motor Shield (L298N))
SHIPPING
LIST
· 2A Motor Shield For Arduino x1