Particle Xenon (BlueTooth + Mesh)

15,00
(18,60 με ΦΠΑ)
077.0014
Άμεση
+
Προσθήκη στα αγαπημένα

The Xenon is a low cost mesh-enabled development kit that can act as either an endpoint or repeater within a Particle Mesh network.

Equipped with the Nordic nRF52840, the Xenon has built-in battery charging circuitry which makes it easier to connect a Li-Po battery and 20 mixed signal GPIOs to interface with sensors, actuators, and other electronics.

The Xenon is best for connecting sensors, motors, pumps, valves, and points of data-interest. Pair it with an Argon or Boron gateway to get all that great data into the Device Cloud.


Main processor :

Nordic Semiconductor nRF52840 SoC

  • ARM Cortex-M4F 32-bit processor @ 64MHz
  • 1MB flash, 256KB RAM
  • IEEE 802.15.4-2006: 250 Kbps
  • Bluetooth 5: 2 Mbps, 1 Mbps, 500 Kbps, 125 Kbps
  • 20 mixed signal GPIO (6 x Analog, 8 x PWM), UART, I2C, SPI
  • Supports DSP instructions, HW accelerated Floating Point Unit (FPU) calculations
  • ARM TrustZone CryptoCell-310 Cryptographic and security module
  • Up to +8 dBm TX power (down to -20 dBm in 4 dB steps)
  • NFC-A radio

Xenon general specifications:

  • On-board additional 4MB SPI flash
  • Micro USB 2.0 full speed (12 Mbps)
  • Integrated Li-Po charging and battery connector
  • JTAG (SWD) Connector
  • RGB status LED
  • Reset and Mode buttons
  • On-board 2.4GHz PCB antenna for Thread/BLE
  • Meets the Feather specification in dimensions and pinout
  • FCC, CE and IC certified
  • RoHS compliant (lead-free)


MPN
:
XENN-H
EAN
:
812035030088

Datasheet (xenon-datasheet.pdf, 2,559 Kb) [Λήψη]