RFid Click
RFid click features CR95HF 13.56 MHz contactless transceiver as well as trace antenna. The click is designed to run on a 3.3V power supply only. It communicates with the target MCU via mikroBUS™ UART (TX, RX), SPI (MISO, MOSI, SCK, CS) INT, RST, PWM and AN lines.
RFid click features CR95HF 13.56 MHz contactless transceiver as well as trace antenna. The click is designed to run on a 3.3V power supply only. It communicates with the target MCU via mikroBUS™ UART (TX, RX), SPI (MISO, MOSI, SCK, CS) INT, RST, PWM and AN lines.
The click functions as an integrated transceiver for contactless applications. The board contains a dedicated internal frame controller and analog front end (AFE) for RF communications. It supports ISO/IEC 14443 type A and B, ISO/IEC 15693 and ISO/IEC 18092 protocols (tags) as well as the detection, reading and writing of NFC forum type 1, 2, 3 and 4 tags.
CR95HF integrated transceiver
The CR95HF has 2 operating modes: Wait for Event (WFE) and Active.
In Active mode, the CR95HF communicates actively with a tag or an external host. WFE mode includes four low consumption states: Power-up, Hibernate, Sleep and Tag Detector. The transceiver can switch from one mode to another.
The Hibernate state has the lowest power consumption out of the four states (1 µA typ. 5 µA max.).
SMD jumpers
Two SMD jumpers are provided on the board. In case you want to use UART interface, it is necessary to solder SMD jumpers in B position. Otherwise, if you want to use SPI interface, jumpers should be left in its default position (A). In that case interrupt pins (IN and OUT) are usable.
Key features
- CR95HF IC
- Operating modes supported: Reader/Writer
- RF communication @13.56 MHz
- Supports NFC Forum Type 1, 2, 3 and 4 tags
- 3.3V power supply
- Interface: UART, SPI
Specifications
| Type | NFC,RFID |
| Applications | Board can be used with 13.56 MHz RFid tags or identification cards. Ideal for tracking and security systems that needs RFID support |
| On-board modules | CR95HF 13.56 MHz contactless transceiver and trace antenna |
| Key Features | Dedicated internal frame controller and analog front end (AFE) for RF comm. available on-board. It can detect, read and write NFC forum type 1, 2, 3 and 4 tags |
| Key Benefits | Supports ISO/IEC 14443 type A and B, ISO/IEC 15693 and ISO/IEC 18092 protocols (tags) |
| Interface | GPIO,SPI,UART |
| Input Voltage | 3.3V |
| Compatibility | mikroBUS |
| Click board size | L (57.15 x 25.4 mm) |
Downloads
mikroBUS™ Standard specification
RFid click Examples
CR95HF datasheet
RFid click Schematic
Click Boards™ Catalog
Customers also bought
