Product Description
The HDL KNX M/D06.1 is a MOSFET dimmer which supports both leading edge and trailing edge dimming. Control over inductive, resistive, and capacitive loads is possible, or the modules on-board manual buttons.
Different load Types
Both leading and trailing edge modes are able to be used on the HDL KNX M/D06.1. The leading edge supports both Inductive loads and resistive loads, while the trailing edge supports capacitive loads and resistive loads. This enables the operation of incandescent bulbs, motors, and dimmable LED lamps.
Protection
To prevent damage to the system and unit, a variety of protective features are included. With an overheat sink, electronic short circuit protection, overload protection, overheat power reduction protection, and a temperature alarm, safety is guaranteed.
Scene Recovery
When the dimmer has been powered off, it is able to automatically restore the last scene used when powered on again. This gives the user a system that remembers their previous scene, and requires no further control.
Manual control
With manual control via six on board buttons, the end user is able to immediately manipulate the switching on & off, and dimming controls. This enables faster fault finding, and reduces the time taken during installation.
● The Dimmer Actuators can dimming for 6 channels independent loads.
● Leading Edge dimming or Trailing Edge dimming for dimmer.
● Parallel channels to form a larger current output .
● The dimmers may be used for dimming ordinary incandescent lamps, low
voltage halogen lamps and other light sources which support leading or
trailing edge technology
● The module functions : Statistics total ON time, Status respone,
Status recovery, Over temperature protection, Read temperature, Over
temperature alarm, Staircase light, Flashing light, Scene control, Scene
dimming, Sequence
control, Threshold control, Heating actuator (PWM).
● Short circuit protection, over load protection, over Heat protection
Datasheet KNX Trailing Edge 6CH 1A Dimmer
Performance parameter:
-Working Voltage : 21-30V DC
-Communication: KNX/EIB
-Dynamic Current: < 15 mA
-Static Current: < 5 mA
-KNX terminals: KNX Bus Terminal – (Red /black) 0.6-0.8mm Diameter Single Core
-Rated Voltage: 220-250V AC (50/60 Hz)
-User Controls: Manual Over-ride switch for each channel, KNX LED & button programming
-Output Terminals: Line In, Line Out for each channel 2.5-4mm2
-Output Current : 1A/Ch, 6Ch
Approved:
-CE
-KNX