Leading edge and,Trailing Edge Technology Dimmers complying with European safety standards and KNX association protocol.Trailing Edge Technology Dimmers Short circuit protection, over load protection,over Heat protection.

Can connect up to 64 DALI devices for address assignment and management.also can be real-time to detect the device fault, such as DALI fault,Lamp fault,Ballast fault, for each channel and group, support Switch ON/OFF，Relative dimming，Absolute dimming,1bit and 1byte statues response function.

10A each Channel, FUNCTIONS 1-Statistics total ON time | 2-Status respone | 3-Status recovery | 4-Upper limit | 5-Lower limit | 6-Staircase light | 7-Flashing light | 8-Scene control | 9-Scene dimming | 10-Sequence control | 11-Threshold switch | 12-Heating actuator(PWM)

HDL KNX USB Interface, DIN-Rail Mount, with USB Conector galvanically isolated from KNX Bus that establish a bidirectional data connection between PC and KNX BUS, Enable addressing, setting parameters, visualzation, protocolin and diagnoisis of the bus devices.

Master/Slave Timer Controller This timer controller is embedded with RTC, can run real time itself, can used as master timer and slave timer.

12CH 10A Relay Module: Main Function | Statistical functions for running time of Channel | Channel statusresponse 1-On/off status can be set when Power-Down or Powerup | Timer Function | Scene Control | Threshold Function | Curtain Control function | Logic Function: And, Or, Xor, Gate | Heating Function: PWM control output

Edge Technology Dimmers complying with European safety standards and KNX association protocol.Trailing Edge Technology Dimmers Short circuit protection, over load protection,over Heat protection.

Leading edge and Trailing Edge Technology Dimmers complying with European safety standards and KNX association protocol.Trailing Edge Technology Dimmers Short circuit protection, over load protection,over Heat protection